Hi all,

Anyone else experienced this strange behavior ? Two x Roco E-Loks both with MX645P22 79948 and 73227 both can be speed matched perfectly using the 28 speed step method but once driving together on my layout using CV 19 and CS3+ with the sound turned either on both or just one locomotive (how I prefer) there is slight delay when starting driving and if you have the sound on in the front locomotive the rear will start earlier and vice versa. I have tried numerous options but cannot solve.

Any advice would be greatly appreciated.

Kind Regards
Richard

Hello

A loc with sound has always a starting delay because of the sound procedure compared to a loc without sound. But this would explain only that what you observe if only one loc has sound activated.

In some decoders you can set the duration of the delay. Check in the manual of Zimo if it is the case on your decoders.

Rgds

Stephan

Hello everybody together

Zitat von nzrailfan im Beitrag #1

---

I have tried numerous options but cannot solve.

---

Solved , yes correct CV273 was the problem both had different values which are now set to 0 , both now in harmony. Many thanks.